SSR Enabled
my105 - No. 1 Race car classfieds
my105 - No. 1 Race car classfieds
SOLD!

This one got away, but check related items for something similar.

SOLD!

This one got away, but check related items for something similar.

6
Sold9128 viewsupdated 2 years agocreated 4 years ago
Share
Watch

Atomic 1000kW Barra ute

$70,000
Ford
Make
Falcon XH
Model
2020
Year
St Marys South Australia, Australia
Location

All brand new, featured in the December 2019 issue of Street Machine Magazine
Genuine reason for sale - $70,000 negotiable (well over $130k spent... stopped counting)
Currently running a run-in tune to fully bed in the engine, yes on low boost (25psi, engine is built to take 50psi) it made approx 800rwhp spinning the tyres on the dyne at 6,000 rpm
Dyno video https://www.youtube.com/watch?v=vOHk6fMXqRc

Many many hours have gone into this car. Bought as an immaculate standard car and has been stripped to a full bare shell. Build with photos available. Many trick items such as the custom recessed firewall, fully removable radiator support panel and integrated water/air intercooler are easily missed.

Atomic semi grout-filled Barra block, Atomic Race ported head
Atomic Race Crank, Fat Rods, Stage 4+ Race cams with VCT delete, valves, springs and retainers
Cosworth pistons and rings
Extrude honed FG Falcon, with 12x 2000cc injectors Hypertune 90mm throttle
Garrett GT47/88 turbo
Genuine LS coils on Tuff Mounts bracket
Triple Walbro in-tank pumps in a custom built fuel cell
Four-inch turbo dump and side pipe with X welded in

Full custom Dynatronics loom, Haltech Elite 2500 ECU, Tuned by Garage 7

MV Automatics built reverse-pattern TH400 with trans-brake
TCE billet 5500 high stall

Wildwood 4 spot rear brakes + parachute and line locker
Pedders prototype height adjustable coil-overs front struts, QA drag racing coil-overs rear
Custom adjustable Falcon steering column with VK Commodore manual steering rack & pinion setup
Custom ladder bar rear suspension with wheelie bars and anti-roll bar
Strange 3:55 full spool inside Currie Enterprises sheetmetal housing braced by Zagari Engineering, 40-spline axles
2000hp capable tailshaft that cost LOTS to build

Weld Alumastar wheels (15x3.5 and 15x12), Mickey Thompson 15in front runners and 33x10.5 slicks

Rod Andrews rollcage
Kirkey race seats
Quick release race wheel
B&M Pro Ratchet shifter
Lexan windows