3E Production Touring Mazda 2 Only 4400km old, fitted with Yellow Coilovers, Enkei wheels, Weld in roll cage, Sparco Seat and RPM Enduro 6 point harness. MA Logbook for 3E Production Touring. Very cheap to run and super fun to drive.
"Mazda RX 7 this a Go Gear rx7 , 200 b triple rotor 407 RWHp ,5b Speed Hewland trans axle ,Space frame chassis chassis no GG16. this car had a full bare chassis rebuild 2019/2020 information and photos available on request , this was a full rebuild every nut and bolt checked and replaced ,chassis was repaired and tubing replaced as required this car has only been on track once since rebuild , has lapped Barbagello at sub 57 sec ,mechanically very good ,this is cams registered as Sports sedan fur
This is your last chance to buy my 1979 Mazda 323 (Rear Wheel Drive) IPRA Improved Production car (3J rules). This will be the final price drop before the car gets disassembled and parted out, as the parts alone are worth far more than the asking price. Recently finished 12th in the 2022 Nationals after starting 32nd and last on the grid (https://youtu.be/1DsazXuHCBc) and given more time and/or a better starting position, a top 10 was definitely on the cards. This car has been hand built by a
Mazda RX7 Sports Sedan. Ex Ivan Mikac Go-Gear built car. Ground up restoration 2018-2020 including chassis/body, transaxle and engine. 2021 Tasmanian State Champioship winner. 12a turbo, Hewland FGB with long and short track ratios, 8 spare wheel centres. Short and tall drivers seats. Can assist with transport if required. May consider sports sedan project as part payment.
Selling new RX8 Bathurst 6 hr car, raced one event. Built to the Production regulations for the Bathurst event. Every component new and serviced. Spare package included with spare new engine and gear box and wheels. Over head Fuel rig included with new hoses. Perfect car to race reliably and cheaply in any 3E Production race or the Bathurst event.
Many hours and dollars have gone into bringing this RX7 Sports Sedan back to track spec after sitting dormant since 2004. See start-up video https://www.youtube.com/watch?v=LPjiyKQ-SUY I purchased this car a couple of years ago and it went straight to the original engine builder John Perkins (VIC) who went through the mechanicals, freshened the engine and updated the MOTEC to an M1 package with new motorsport sensors through out. It has done dyno runs only since. It runs an early Racing Beat
Series 1 RX7, CAMS logbooked 3J, S4/5 13b, bridgeport built by Rotortorque, only 4 race meets old. Garrett T04 turbo, Microtech LT10. Makes 410hp at 16psi, on E85 only. Still on wastegate pressure, will easily make over 500 comfortably with more boost. S5 turbo gearbox, Kaaz diff. CAMS spec weld in roll cage. AP racing brakes including bias adjuster. Big fuel system, TAARKS surge tank with 2 x 460s, twin carter lift pumps, Indy blue injectors just been serviced and flow tested. All PTFE fuel lin
For sale is the Dick Ward Go Gear sport sedan. As built and driven by Dick in sport sedan races in the 80s. This car presents in excellent condition. - 13b PP engine using MFR factory peripheral port housings and making 300hp. - Hewland transaxle stamped as ex F1 F.Williams. - full chromoly space frame chassis - magnesium uprights - lots of top spec features as raced in the day. - 600kg makes it an absolute blast to drive and extremely fast This car is eligible to run as invited in Historic
Mazda 808 coupe. Built to Cams 3j rules (Improved production racing Australia IPRA) a popular category in all Australian states, with Cams approved Wildridge fabrications full roll cage and log book, suitable for many motorsport activities. Motec M84 ECU (enabled), Motec C125 display (race kit enabled), Motec PDM15 (runs all lights etc, no fuses or relays required). Full car professionally rewired by Armour motorsport with Tefzel mil spec wire. Mazda bp1.8 built by Boostworx of Adelaide with Ma
Mazda RX7 Series 2 Contact me for a video of the car. Series 3 rear end with 4.4 ratio LSD KYB Sockers Split tail shaft Series 4 turbo gear box Lightened flywheel Heavy duty clutch Selectmaz 13B Bridgeport with 3,900KM since built Racing Beat twin exhaust system 51mm IDA with extended fuel bowl 3 core radiator Series 4 front brakes and disc’s
Set up for Pscr. 2B/2F Fast and reliable silverback gorilla . See in action on https://www.YouTube.com/playlist?list=PLWzwZ0N0jhaKg1k66xego6T2RK7SFOaG8Q. Wonderful entry to racing . COVID and distance got me . Best value on the market
For sale, new RX8 Cup race car. ready to race in the RX8 Cup Series. very cheap way to race in a one make series with RX8 rotary cars. All built with new race parts ready to hit the track in a fast growing National series and CAMS state championship. cars are all the same spec.Fresh running gear. New race engine.
Mazda 6 Diesel Race Car. Perfect Car for the up and coming Bathurst 6hr, AmChamps National Championship & State Championships. Built by Mark One Engineering for endurance racing. - Brown Davis National Spec Rollcage, - Dry Brake Fuel System - Motec C125 Data Dash - AP Racing Brakes - Tein Race Suspension - PWR Radiator - Race Comms - Boost Logger No expense spared, regretful sale due to business commitments.
Ex F1 Celebrity Challenge car. Built by Mark One Engineering for endurance racing. Built to run in Aust Manufacture Championship and any other Production car championship. - Dry Brake Fuel System - Motec C125 Data Dash - AP Racing Brakes - Tein Race Suspension - PWR Radiator - Race Comms - Boost Logger No expense spared, regretful sale due to business commitments.