1994 Bob Meyer Dragster

Price reduced for quick sale way below replacement value

Unfinished rebuild and freshen up project that stopped due to health issues

Presenting a very well looked after 250-inch Dragster Rolling Chassis, constructed by Bill & Wayne Jones Weldwell Engineering in the early 90's.

Easy to bring up to latest specs

The chrome moly rolling chassis with air brushed painted steel and fibreglass body panels is less engine, gearbox brake lines and diff center.

This car has run 206mph in 6.68 seconds with a blown small block Chevrolet engine in CCDragster.

The car is fitted with high-quality Willwood brake caliper and a 9-inch rear end with 40-spline axles.

Has wing struts and supports but no wing.

Good handling easy to drive car that always goes in a straight line

It's an ideal and inexpensive race car for either someone just starting out or an experienced racer.

This is a chance to go racing in a good quality vehicle for a fraction of the cost and time it takes to build a new car from scratch.

The chassis is suitable for small block engine, either supercharged or naturally aspirated.

For further information on this Dragster chassis, please reach out via private message.