69 items between $10,000 & $20,000 for sale

Excel X3 race car excellent value for entry level motorsport, dual log books AASA and Motorsport Australia. New one piece Fiberglass dash, AGI bolt in cage, Cobra Monaco race seat and harness, new excedy clutch, new tyres, car is very clean and tidy inside and out, Mechanically good, standard suspension (controlled Shocks cost $2500). Comes with a spare Silvertop engine and some spare panels car is located in western Sydney. Selling as circumstances have changed.

Restored 1981 Avanti Formula Vee Rebuilt all brakes: shoes, drums, master, slaves and lines New clutch master and slave Brand new Dunlop tyres New floor tray and spare New ignition and battery New starter switched and rain light New schroth seatbelt New gauges Carby dyno tuned by developro to run on 98 New steering wheel New battery New wheel bearings Wheel aligned and safety checked by BRM New front nose cone and spare. Pretty much the car has been made like new a

FOR SALE VN V6 5 speed Commodore Rally Car $12,000 with all spares or $10,000 car only This car has only done a hand full of event mostly T.R.E’s and a couple of rally sprints. The car includes: • Intercom • marsh seats • SA rally reg • MSA (CAMS) approved cage Other spares include: • 2x T5 gearbox • 2x complete diffs (housings, axles ECT) • Near complete set of panels • 3x sets of wheels with well used rally tyres Won’t come with belts due to needing new ones because being out of date. It is

2000 GC8 WRX Rolling Shell, was being built for Tarmac Rally and has a CAMS certified cage. Does not extend to the front towers at this stage, although the strut tops have had cromoly plates added over them and the A pillar to chassis rails have extra bracing. Has sill jack points also. The cage has double diagonal bracing throughout and gussets everywhere. Seat mounts are welded in also. Was a clear title undamaged road car and has been kept indoors since it was pulled off the road in 2014/15.

Nissan 370Z rolling shell, custom Roll cage with side intrusion, air jacks mounts, billet steering Coolum, front nudge bar, lift off doors, rear separation wall, the fabrication so far has been over 16k without the pedal box and airjacks, and velo seats. I have the standard hatch and bonnet and guards but no lights. Car was imported with flood damage originally so not in a accident and written off, it’s a straight clean shell. I’ve lost interest so my lose will be someone else’s gain

G force gf 2000 McLeod clutch and billet Steel flywheel Ser5 bellhousing Ihra approved steel shield Starter motor right hand drive shifter Gearbox crossmember Mark Williams Tail shaft yolk complete set up from Pac performance rx3 13b dentist has run 7.0 all in perfect working order ready to use $12000