50 items between $10,000 & $20,000 for sale

Fully enclosed hydraulic custom car trailer. These are over $75,000 brand new. It has been a great workhorse for the business of transporting cars. Spent $15,000 the past two months by putting full new electric system and brand new upgraded hydraulic motor and both front arms rebuild with much stronger strength It has new side curtains and easy to load and unload. Can fit all cars as the internal width is 2 metres and high 2 metres length 8.1 metres with front seperate compartment. no low bal

track car all wheel drive built for pheasant deputy 4 hr series aasa log book 2 sets of wheels radio intercom new clutch fitted new timing belt race brake pads cheap track car also suitable for production car racing

Excel X3 race car excellent value for entry level motorsport, dual log books AASA and Motorsport Australia. New one piece Fiberglass dash, AGI bolt in cage, Cobra Monaco race seat and harness, new excedy clutch, new tyres, car is very clean and tidy inside and out, Mechanically good, standard suspension (controlled Shocks cost $2500). Comes with a spare Silvertop engine and some spare panels car is located in western Sydney. Selling as circumstances have changed.

RPS Carbon race brakes, 2x sets of 380mm front discs and 1x set of 356mm discs and pads, comes with hats, I purchased these to run on my V8 Supercar and then my racing series banned the used of Carbon brakes, hence these are no longer of use to me, we did around 10 laps of initial testing and one set of front discs is still brand new. These weigh roughly half of what the steel brakes we run do. Selling for half of my purchase price. Contact Nick +64275536300 or email nick@chesters.co.nz

2000 GC8 WRX Rolling Shell, was being built for Tarmac Rally and has a CAMS certified cage. Does not extend to the front towers at this stage, although the strut tops have had cromoly plates added over them and the A pillar to chassis rails have extra bracing. Has sill jack points also. The cage has double diagonal bracing throughout and gussets everywhere. Seat mounts are welded in also. Was a clear title undamaged road car and has been kept indoors since it was pulled off the road in 2014/15.

Nissan 370Z rolling shell, custom Roll cage with side intrusion, air jacks mounts, billet steering Coolum, front nudge bar, lift off doors, rear separation wall, the fabrication so far has been over 16k without the pedal box and airjacks, and velo seats. I have the standard hatch and bonnet and guards but no lights. Car was imported with flood damage originally so not in a accident and written off, it’s a straight clean shell. I’ve lost interest so my lose will be someone else’s gain

G force gf 2000 McLeod clutch and billet Steel flywheel Ser5 bellhousing Ihra approved steel shield Starter motor right hand drive shifter Gearbox crossmember Mark Williams Tail shaft yolk complete set up from Pac performance rx3 13b dentist has run 7.0 all in perfect working order ready to use $12000