Holden VX Commodore race car

OPEN TO REASONABLE OFFERS

MAY TRADE FOR SOMETHING OF INTEREST UP TO 50K VALUE + CASH

Selling my VX Commodore race car. It was built for Replica Tourers but is also suitable for QTCC, Sports sedans, Vic V8’s and other local classes.
Car specs:
L98 6 Litre Race Engine built by Fataz competion Engines - Only the best parts were used. It made a genuine 500+ rwhp on roller/chasis dyno at 7200rpm on 98 fuel, not inflated figures like some other cars post.
Engine built at 10.5:1 compression for reliability and longevity so there more in it if you wanted to go that way.
F.A.S.T manifold and fuel rails
Aeroflow 102mm billet DBW throttle body
Granatelli Motor Sports Malevolent Coil Packs and 0 Ohm ignition leads
G&D Billet Alloy 9 litre sump
1 7/8 headers
Custom twin 3 inch exhaust into side exhaust
Emtron KV8 ECU
Emtron 7 inch dash
Emtron button pad
Emtron full milspec engine harness
car has had a full professional milspec rewire by Whitey’s wiring - no original wiring in car
D2 Forged 1 piece monobloc brake calipers with 2 piece full floating hubs and discs - 356mm 6 pot front and 356mm 4 pot rear
all new brake and clutch lines throughout the car
Tilton DBW 3 pedal, pedal box with brake bias adjustment
MCA red coilovers
Magnum F t56 gearbox with S1 sequential shifter with short shift linkage
GJ Drivelines 1 piece aluminium tailshaft - good for 1400hp
Upgraded diff with 31 spline axels and helical LSD with 3.7 diff gears
Upgraded stronger drive shafts / cv's
Complete new fuel system including 15 gallon baffled fuel cell, 5 litre surge tank, lift pumps, fuel pumps, fuel regulator and -8 fuel lines.
Sparco ergo 2 race seat
Racetech lightweight 6 point harness
National spec weld in roll cage built by CJ Mobile Fabrication
2 x sets of 18x10 semi forged Koya wheels fitted with Kumho slicks
Astra electric power steering pump
Sparco 330mm steering wheel
PWR radiator
Powertrain 7.25 inch twin plate clutch with button flywheel and B&M flexplate
Fabhouse custom front lower control arm set
Fabhouse chromoly lower arms, caster arms and caster mounts
Tuff Mount engine, gearbox and diff mounts
power steering and engine oil coolers
V8 supercar body kit
new front and rear windscreens
new headlights and tail lights
Perspex side windows
doors gutted
It will also come with a brand new Moroso Accusump setup
Car weighs 1420kg without driver
AASA log book

This is a brand new build and has only done a dyno session to run the engine in and tune plus a track day to bed everything in. It sounds and goes awesome.
This has been a 5+ year build but unfortunately due to financial reasons I have to let it go.
It does have some blemishes on the front bar from when I did something stupid when unloading it.

It owes me well above the asking price.
All reasonable offers considered.

Located in Burpengary QLD