26 Porsche in Australia for sale

Built to suit a Porsche cup car with wider ramps. Has tyre rack, tool box, electric winch & lockable coupling. Always kept under cover.

Porsche parts including but not limited to. Fresh Gear box, doors, bonnet, roof with support frame, front guards, front lights, front and rear bumper, fuel cell, carbon rear engine cover small damage, front sub frame, full set of new radiators and much more any parts needed just reach out. Also have complete car for sale as surplus to requirement. All parts are currently in NZ but can be easily sent over. I am based in South Australia.

I have a bunch of Cup Car Parts for sale as follows. • 2 sets of 997.2 Forged factory 1-piece rims $4000 per set • 1 set 0f 997.2 BBS 3-piece rims $3500 • 2 sets 997.1 rims with wider rear inner section to run 997.2 tyre $2500 per set. • 1 x 997 bonnet Used $700 • 1 set new 997.2 factory rear wing uprights $600. • 1 x 997.2 replica rear engine lid $800 • 1 x 997.1 factory engine lid $1000 • 2 x 997 Cup S replica front Guards $1800 • 1 x 997 Cup S replica front Bar $1500 • 1 x 997.1 LH factory Cu

Isuzu FVM 1400 Manual transmission, Duel rear Axle, Rigid 4 car enclosed transporter. Built to a high standard on a new chassis in 2015 by Aldon Transport Engineering in SA. 4 car capacity with fold down top level ramps, tyre racks and storage lockers. Purpose build for GT/Porsche/Open wheel cars with an abundance of tie down points, internal winch, Dhollandia 2.5 ton tailgate with remote, Honda Genset, external floodlights and internal LED lighting. Has limited km @ 233,000, fully maintained, g

Set of 4 unmarked Porsche Spyder style Alloys 20" Front, 21" Rears To suit a 992.$4900 the Lot.No Tyres, Unmarked,Genuine Porsche 992 Wheels.Grey,Photos attached. NB Porsche Centre will sell a new set at $16,000 & that is with a 15% Discount.

UPDATED PICTURES - This large F350 is a rare find in Australia — the Centurion conversion offers luxury seating for 8 people, a strong and capable chassis, and loads of classic 80s character. This F350 XLT Centurion is more than just a vehicle – it’s a statement. Whether you're into classic trucks, need a spacious cruiser for the family, or want something unique for towing your race car, boat or caravan, or just touring, this beast ticks all the boxes. Vehicles like this are few and far betwee

1 bolt-in front section of Roll cage for Porsche GT4 981 or 718 (not RS) road car with Clubsport spec. This is in its original box/crate from Porsche and is OEM and has never been fitted. Fully DMBS and CAMS approved. Original cost $10,000.

Two sets of 911 Plates for sale - one set "9114ME" at AUD$20,000 and one set "A911ST" at AUD$30,000

AUTOart RIMS OFF MY 997 GT2. UNDAMAGED & COMPLETE WITH PORSCHE WHEEL CAPS MODEL VYC 18 SPECS IN PHOTOS 2 & 3 PICKUP BRISBANE OR CAN SHIP WORLDWIDE AT COST

SOLD...SOLD...SOLD...SOLD...SOLD PARTS FOR SALE: Front splitter complete, Bonnet new, Plastics, car sets of new GKN driveshafts ( Blue, Green, Red, Orange ), car set BBS wheels with new Michelin tyres fitted, new bonnet, second hand headlights and tail lights, new plastic undercar floor ( most pieces ) lots of plastics and brackets and more!

Car set of fully maintained BBS 997.2 Cup Car 3-piece wheels. $3495 Also a new set of unused Michelin wets. $1995

PORSCHE 996/993(964/944) 18 INCH BBS GT3 RIMS IN TOPCONDITION 7,5jx18 et 50 10jx18 et 65 These Nice Rims fitted under a Porsche 996/993 Narrow Body ,and with spacers rear from 10 mm under a Porsche 964 and Porsche Model 2

Selling my Rods Engineering Lifetime Trailers tri axle race car trailer. It is... A 2013 Model 7.8m Long 2.45m Wide 3.7 High Weighs 1700kgs ATM is 4000kgs Is a beautifully constructed trailer with an aluminium frame. In excellent condition. Has a full width pull out deck that comes out from the side door. Has basic sleeping facilities that could be added to very easily. Lots of overhead storage Was setup for a Porsche Tows lovely.....has brakes on all axles. Priced to sell quick at $26000

I have for sale a rear body clip of a Matich SR3 In very good condition Been modified above engine cover to suit Porsche motor, but easily returned to standard. I also have the mold for original SR3 rear clip for sale separately.

H2O-LOL. Water???? Laugh out loud!!! Tell the world where you stand on the whole water cooled - air cooled debate! Brand new plates...never mounted.

Used for 18 months - Pristine condition Never tightened with a rattle gun, always hand tightened. Purchased new from Porsche for $2k. Always greased with the right product. Will sell for fixed price $1050 for all 4 centrelocks and post anywhere in Australia.