81 SEAT for sale

ford Mustang GT Mach 1 built by Ryan Mcloed was on pole for 2022 Bathurst 6hr it has 4 camera system Sparco seat on Ricaro adjustable slide 100 ltr premier fuel cell FAI approved Brembo billet brakes 378 Brembo rotor modified rear brake calipers with floating rotor Murray Cootes Gold shocks big range of eibach springs included new Mach 1 spec engine with boundary oil pump Mahle pistons Manley rods psi valve springs epoc multi angle valve job ATI balancer dynoed by roger Higgins new Suncoast 10

Replica Penske Race car Group N logbook Freshly built & painted car having only completed 1 Race meet at QR finishing 2nd Brand new muncie gearbox with gearbox pump & cooler PWR radiator Racing Tri Y exhaust Ceramic Coated double adjustable Afco Shocks Howe Ball joints & tie rod ends 2 sets of wheels Aluminium fuel tank New Harness New seat selling less engine

Holden VE Track car, Cams Approved Cage, Sparko race seat, Has Freshly built motor. Crow Cam, LS3 Rectangle Port Heads, Arp Hardware( head bolts, Rod Bolts, Cam Retainer Bolts, Balancer bolt) Mellings High Flow Oil Pump, Oil Cooler, Fuel Cell, Baffled Race sump, New Coil Packs and Leads , New Bosch 750CC Injectors, XYZ Coilovers, HSV AP racing Brakes -(new pads) 3.7 Diff, New Battery, Brand New Freshly Installed Hatch System Has had all weight removed where possible .Has done 20 Laps at QR for

Registered Race Car Built for Targa & Road use 2019 Lotus Exige 410 Sport Roll Cage Fitted by Lotus Aust Bolt in front half for registration Race Harnesses Fitted Retains Factory Seat Belts Spare set of race Wheels Only 9,500 K’s One very sad owner

VY Commodore SS circuit/sprint race car. 6L Dart LS Next. Forged and balanced rotating assembly, 12.5:1 compression on E85. 470 rwhp on safe tune. No shortcuts taken - all the best equipment throughout. Engine has only done two sprint meetings. Selling to move to a different race category. Also : * Trickflow GenX 220 heads * FAST LSXR 102 manifold, FAST 102mm throttle body * Deatschwerks 60lb/hr injectors * Crow 871741 camshaft * Lunati link bar lifters * Moroso oil accumulator * PWR oil coole

Complete Race Ready - TA2 - Transam TFH Racing Mustang. Raced once under the TFH Racing Team at QR, Engine has done 3 shows from having a freshen up at HCC. G-Force Gearbox with upgraded light weight flywheel, Tilton Triple plate Clutch, Racetech seat. Wilwood Brake Rotors and Pads comes with spares below, 1x set of Hoosier Wets. 1x set of Howe Jack Stand. 1x set of Wheel Hub Traveler Mounts. 1x pair of front damper Traveler Mounts. and also spare used Brake Rotors, Brake Pads, Springs. Set up a

Here is an opportunity to own a factory built TRD Ae82 . This would be very competitive in the under 2l racing in group A /C . And would mix it up with a lot of the mid pack cars .. Toyota Corolla Grp A A piece of motorsport history Built by TRD Japan for team Toyota Australia. Toyota group A Corolla , Trd ae82 gtfx , was brought into the country early 1986 for the 1986 under 2l. championship. That John smith ran and won its first event . And won the championship. It ran 1988 Bathurst a

JPS BMW 635 csi E24 Built principally as a Club racer this road registered 635csi has been developed by renowned BMW race engineer Pip Barker. Features are as follows:- Six cylinder 3.5 litre engine 5sp Manual Bore 92.6mm Stroke 86mm Pistons Mahle Motorsport forged hemispherical dome Conrods factory, lightened and shot peened with new rod bolts Comp ratio 11.5/1 Camshaft Cat Cam 326* duration, 11.15mm valve lift, valve clearance 0.30mm intake and exhaust - cold. Valve springs Cat Cams in

Perkins 028 Replica build of the Parsons transport 55 vs commodore. Dual 3J log booked MA and AASA, Ipra, Replica tourers, QTTC, Sports sedans, Vic v8s. Ran it in November 25 with replica tourers at QR with a pole and 4 from 4 race wins. SBC 010 block 6ltr, 18 deg Hrd heads, 13-1 comp, Aed carby and gm 2 piece intake manifold, carillo rods, diamond pistons, jesel rockers and Msd and timing belt, callies magnum XL crank, steel caps and girdle. Racepak logger dash. New barnes dry sump pump, pe

FOR SALE – BRAND NEW LEGEND CAR PACKAGE $48,999 – READY TO RACE + FULL 2026 SERIES ENTRY INCLUDED This is the best value turn-key racing package in Australia. Buy a brand new Legend Car and get guaranteed entry into the entire 2026 Hi-Tec Super Series — no waiting lists, no missing out. Why Race a Legend Car? • Equal machinery & true driver parity — if you’re fast, you can win immediately. • Yamaha MT09 engine capable of multiple seasons without a refresh. • Like a go-kart on steroids — in

Toyota 86 2013 Scholarship spec. Ready to go in the 2026 season. Good condition with new engine after Rnd 1 2025. Comes with 2 sets wheels, new dunlops, used dunlops, used Hankooks from APC category. Log booked, new gearbox in August. New front shocks as spares, spares to go with it. Well maintained and will come with passenger seat for rude days

This 2013 Ford Mustang Boss 302 ‘Laguna Seca’ is 1 of 262 manufactured by Ford in School Bus Yellow and 1 of 765 manufactured by Ford world wide (with 2 known to be in Australia with this Laguna Seca being one of the last 22 produced). This Laguna Seca currently has 13,146kms from new and has been served every 12 months regardless of use. This Laguna Seca was delivered with the Boss 302 car cover, Boss 302 floor mats, front splitter, red track key, owner pack including a letter from the Ford P

Honda crx delsol. B16a2 fully rebuilt with 20tho over 13:1 carillo forged pistons and rods, acl race bearings, cosmetic mls head gasket, crank shaft crack tested and polished, block bored, torque honed and decked. New high volume oil pump and morosso large capacity sump. Pcv delete kit fitted with custom made catch can and large lines and an fittings . Head is ported with kelford cams, kelford adjustable cam gears, kelford valve springs and retainers and runs a custom made intake manifold with 4

Pantech 12-18Twith 2500kG tailgate lift , only 2 years old,air con front and back, 240 volt lighting and power points,bench, storage shelves , small upper storage area, sleeper area behind driver seat , heaps of tie down points ,280HP turbo diesel, 8 speed , 2 speed diff.Pan area 7.8m long,2.4m inside width, 2.7m high, mech excellent, good rubber all round, 4 wheel disc brakes. Suit any kind of race car, new injectors 2 years ago.peter 0418767990

Mitsubishi EVO V Race Car - No Engine, ECU, Transfer - 1995 Evo V - Weight 1250kgs when Engine and Gearbox installed - MotorSport Australia Approved Full weld-in National level roll cage with Logbook - Fiberglass Doors and Lexan Windows - Full Respray in White when these doors and windows were installed in 2019 - Racetech RT4119THR Seat with head restraint and Roll Cage mount + Velo Passenger Seat – Both with 6-point harnesses. - Lithium Battery mounted in Rear. Compliant Kill switch - Standard

Log booked MA Improved Production National roll cage ( Scott’s Rods) Full race exhaust ( Scott’s Rods) MCA Reds coilovers with latest spring package 2 full sets of 18x8 Koya wheels and tyres 235/18 Yokohama ao50’s Tomei baffled sump, oil cooler, Perrins cold air intake, 2016+ update red alloy intake and coil packs Flex fuel setup with gauge up with gauge run 98 to E85 Full ECU tune for all mods Brakes GTS with T3 DBA rotors and circo race pads Fenix full alloy radiator Rear adjustable toe arms

1 of only 300 ever produced, all identical. All in Ford Performance Red, lightweight, radio delete, rear seat delete, air con delete, sound deadening delete, factory fuel cell, all here noted factory specific to 2000 SVT Cobra Rs 1st with 5.4 quad cam V8, first with 6 speed gearbox, 1st all independent suspension, Borla exhaust [factory side exit] Bassini x pipe, Bilstien shocks, Brembo 4 spot caliper brakes, higher pound springs, Recaro seats, Cobra R Binder/compendium irreplaceable, speciali

Toyota 86 Production Car Just finished with only 2 race meetings, including 2 Class wins
 Racetech seat 
Sparco Belts
 Bolt in cage
 Grimmspeed Airbox
 4 pot front brakes
 2 pot rear brakes 
MCA coilovers
 Currently set up for Production Cars with Yokohama 050 tyres, can also be used in Replica Tourers or Production Sports. 
Ideal for Racing, Time Attack or just a fun track car.
 Happy to provide track support, on going maintenance and car storage if needed.

New engine done only 2 hours total klms 5,366 Cage SBH Cage roof Cage doors Tyre Mount Fuel Tanks SBH Rad relocation Tank plumbing and pumps Gusset Kit Parts Nerf Bars SBH Welding frame gussets Wiring Switch pro Cut off switch Fire extinguisher and brackets Misc parts Exhaust Seat brackets Seats Harness Fifty six suspension arms King shocks Powder coating Intercom Radio Rugged helmet pumpers Full race prep for more info contact Brad on 0408860237

FM mustang GT with Mach1 upgrade 3E production car built professionally by Ryan Mcloed Racecar's in 2021 car had 10000 km on road now has 15000 km it has a new motor done 350 km onlywith Mahle pistons Manley rods bowndary oil pump heads done by KRE with psi valve springs dynoed at roger Higgins with excellent power has Suncoast transmission cost 20k bullet proof the car has Brembo race brakes premier 100 ltr fuel cell Murray Cootes gold gas shocks Eibach springs big sway bars new gikon diff pwr