10 items for sale
Most Recent
Most Recent
Keyword
Price
All Results
42
Roll Cage
Overview: • This Chevrolet Camaro has been with its current owner for almost a decade after acquiring it from Tennessee and shipping the car to Australia • Under its previous ownership in the USA, the car ran in the Sports Car Club of America GT1 and GT2 classes • It sports a new AR Bodies muscle car shell on a Panoz chassis that was assembled by Penske Racing to an incredibly high standard • Under the bonnet sits a Chevrolet LS1 engine putting down 400hp to the rear wheels • The Camaro has bee
6
Completely rebuilt over the last period of Covid, ground up restoration, has not been on a track since rebuild. Fitted with a Nissan FJ 20 ET engine with forged internals and Motec management. Will need testing and sorting, just been dynoed at low boost to give the engine a bit of run time, comes with mounted wets and spare new fronts, a complete new forged engine in dismantled form, 3 engine blocks and 4 cylinder heads, and a mass of spares including 2 gearboxes. Was originally raced bu Keith L
8
Roll CageLog Book
S3 RX7 Rally car, fresh rebuild with only two events since completion. (2022 Alpine, 2023 Southern Cassic) 13B Bridge port with 48IDA, approx 250hp ATWs, stainless extractors, remote oil filter, new PWR oil coiler with new oil lines RX8 close ratio gearbox S3 4.89 LSD with strengthened housing MCA with remote canisters, two events old S4 steering, struts and 4 pot calipers All new wiring loom Twin carter fuel pumps Braided fuel and brakes through out Pedal box with Willwood cylinders Hydraulic h
14
Roll Cage
Chevrolet camaro 1968 drag car tabbed 15 inch wide wheels Dana diff front fiberglass clip imported from states. . Cage so much work in car left hand drive set up for big block Chevrolet twin turbo also have pipes made for twin gt42s
4
Roll CageLog Book
Competed in the 2023 National Trans Am Championship and finished inside the top 10. Professionally maintained by Dream Racing Australia between each event. New front and rear brakes (Pads & Rotors) Motec Tps sensor upgrade, Soild plate clutch upgrade, Larger oil cooler upgrade, Air box upgrade, Tail shaft with upgraded yoke and new uni-joints, Rebuilt diff, Recently serviced gearbox, Spare Front Bar, Spare Sway bar, 8 Rims (4 x slicks & 4 x wets) Leak down test performed after last round
4
This immaculate C6 corvette is race ready with no expense spared. Some features include the following: Coil over suspension QA1 suspension Front splitter Rear carbon fiber wing Upgraded brakes 6 piston front and 4 piston in the rear Auto blip computer Quick release steering wheel Roll Cage Fuel Cell Haltech dash with new wiring approx $10,000 Light weight racing battery Isolators Polycarbonate front windscreen Polycarbonate rear windscreen Car has been completely guttered only weighs 1,200 ki
14
Log Book
This is a genuine NG Elfin with build plate EP 002 and comes with current log book and COD. It has had extensive development work and is a front running car with top HP engine, weight reduction where allowed and sorted steering and suspension. It comes with 2 sets of wheels and spares include a nose cane, brake drums, trailing arms, distributor, front shocks and assorted items. Wheel alignment bars are also included. Last outing at Phillip Island Festival of Speed qualified 3rd out of 16 cars.
10
Roll CageLog Book
Genuine NG Elfin Formula Vee complete with COD and Historic Log book. Has been in use over the last 12 months with the last event being Winton on 9/10 September. The car is ready to race. Some spares.
26
RegisteredRoll CageLog Book
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute