7 Holden for sale
Most Recent
Most Recent
Keyword
Price
Listing Type
All Results
6
Registered
Holden Torana sedan 1975 LS1 / T56 F.A.S.T. intake AFR cathedral port heads Comp Xtreme Energy cam 2000-7000 224/230, .581"/.588" lob sep 114 Comp cams hydraulic lifters Yella Terra true roller rockers Accel 40lb/hr fuel injectors Mal Wood Under dash Hydraulic clutch pedal assembly Mal Wood Reconditioned T56 and organic clutch B&M shifter Altra 9 A9 axles 28 spline Wilwood Dynapro big brake hub kit 12.19" diameter vented rotor Wilwood Brake master cylinder and Combination proportioning va
19 1
Roll Cage
Brand new 383 Chev Roller engine Hillborn injection, powerglide. MSD ignition, 35 spline maxispool diff 4.33 diff gears, Harrop alloy diff carrier, deadenbear delaybox, chute, Convo Pro rims, the list goes on. Ground up build, bare metal respray, this car is a true steel body car with everything done and ready for its debut run down the 1/4mile. Receipts for engine and work total well over asking price. Further details contact Chris on 0409348441.
6
Log Book
FOR SALE 2010 HOLDEN VE COMMODORE UTE SSV SET UP FOR STREET – TRACK CAR – DRAG RACE STREET REGISTERED WITH MOD PLATES QLD REGO 5-24 24500KM ENGINE 6.0 LITRE 495KW ON BACK WHEELS 1180 N.MT FORGE PISTONS ROD BOLTS CUSTOM CAM DOUBLE VALUE SPRING HARROP AIR INTAKE E85 INJECTORS E85 PUMP AND SURGE TANK 2300 HARROP SUPER CHARGER MANUAL 6 SPEED GTS S1 SEQUENTIAL SHIFTER CERAMIC CLUTCH WITH CUSTOM SLAVE CYLINDER 1000HP DRIVE SHAFT WITH 9” YOKE TRU TRACK DIFF CENTRE 4.11 GEARS 1000HP DRIVE SHAFT AXL
10
Statutory write off and fully repaired, We have photos of the damage which was the rear of the car,all receipts are available as well. Being a stat write off this vehicle can not be registered in Australia, can be used for track or export outside Australia. it is priced below our cost and needs to GO.
26
2012 Holden ve track ute cannot be registered. 5.7 LS1 vcm7 cam, ported heads, OTR cold air, trunuin upgrade, buckets, oil pump, timing chain, push rods, springs gaskets were all upgraded at same time was done about 1.5 year ago at KTMR performance. twin into single 3.5 exhaust sounds tuff,all braided oil lines, catch can, oil cooler, oil accumulator, powersteering cooler, coilovers, diff has a harrop full spool rated to handle 1000hp with 3.7 diff gears custom tailshaft (dount delete and bigg
10
PRICE REDUCED AGAIN! Calibra 117k 2.5 v6 man red this car would make a good hillclimber or trackday car has alcon 4p mono front calipers dba club spec t3 330mm rotors alcon advantage 320mm rear rotors 2p calipers arp wheel studs 5x120pcd eibach coils kyb eurospec shocks poly bushes front&rear 17/7 alloy wheels fed rsr 215/40/17&235/40/17 fed 595 rear. Have 3.2 v6 from 2004 vectra with cat cams pac v/springs arp head bolts new balancer mtec billet flywheel with arp studs crossram intake off 3.0l
5
Roll Cage
VY Commodore Drag Ute. Drop an engine setup, ecu and converter in and go racing. Has Coan built T400, Harrop full spool 1000hp rear end, 3" 2 piece chromoly tailshaft, 7 point chromoly cage, chromoly front end, chromoly v6 k frame (can buy LS mounts to suit), wilwood booster delete master cylinder, full fire suppression system, drag bags in the rear, custom built light mags 4" fronts 10" rears, light weight brake rotors and callipers, fibreglass bonnet and doors, perspex front and rear windscree