10 items for sale

Completely rebuilt over the last period of Covid, ground up restoration, has not been on a track since rebuild. Fitted with a Nissan FJ 20 ET engine with forged internals and Motec management. Will need testing and sorting, just been dynoed at low boost to give the engine a bit of run time, comes with mounted wets and spare new fronts, a complete new forged engine in dismantled form, 3 engine blocks and 4 cylinder heads, and a mass of spares including 2 gearboxes. Was originally raced bu Keith L

New AR styled fibreglass body on Panoz frame. Panoz frame assembled by Penske Racing to incredibly high standards. This car is powered by an LS1 Chevrolet motor Z06 243 with Tilton triple disc clutch assembly. Included are General Motors performance parts, ASA CAM, rods and lifters. Penske shocks all round with TSW wheels and Hoosier slicks. Wiring harness is new with modified PCM, ATL fuel cell with black box surge pump. Car includes many spares: 4 new wheels with Hoosier slicks 2 Continental s

Competed in the 2023 National Trans Am Championship and finished inside the top 10. Professionally maintained by Dream Racing Australia between each event. New front and rear brakes (Pads & Rotors) Motec Tps sensor upgrade, Soild plate clutch upgrade, Larger oil cooler upgrade, Air box upgrade, Tail shaft with upgraded yoke and new uni-joints, Rebuilt diff, Recently serviced gearbox, Spare Front Bar, Spare Sway bar, 8 Rims (4 x slicks & 4 x wets) Leak down test performed after last round

This immaculate C6 corvette is race ready with no expense spared. Some features include the following: Coil over suspension QA1 suspension Front splitter Rear carbon fiber wing Upgraded brakes 6 piston front and 4 piston in the rear Auto blip computer Quick release steering wheel Roll Cage Fuel Cell Haltech dash with new wiring approx $10,000 Light weight racing battery Isolators Polycarbonate front windscreen Polycarbonate rear windscreen Car has been completely guttered only weighs 1,200 ki

RX8 drift/track car project I have since given up on due to work commitments and a lack of time. I'd rather avoid parting it out. Includes: S1 RX8 chassis (stat write off, perfectly straight, no damage or rust that I've found). - cut out OEM driver seat mounting to fit race seat lower (havent patched hole yet). Custom shortened front uprights New LCAs New brake rotors New PMU pads New braided front lines New Custom valved coilovers New wheel bearings/hubs Wet NOS kit (10lb bottle) Other rando

Mazda in excellent condition, recent service, garaged, Mazda BP GTR Motor with factory Ihi ball bearing Turbo, 221 KW @ rear wheels s/5 gearbox, new h/d tailshaft triple plate tilton, alloy flywheel 4.11 detroit locker.S/4 breaks all round ht 10 pads new front koni struts, harness, autometer gauges intercooler spray 48’s. CAMS log book. ID plates and could be registered if changed to roadworthy.

Holden VR Series 2 Commodore unfinished project rolling shell would suit Circuit racing Drifting, has a full 6 point cams approved Roll cage fitted, two brand new cams spec Pro Force Racing seats fitted along with brand new Pro force 5 point racing harnesses , New OMP Racing steering wheel fitted, rear safety Fire wall has been installed, the whole inside of the car boot under bonnet n door jams have been painted in 2 Pack White, the whole underneath of the car was cleaned prepped n sprayed in c