SSR Enabled
my105 - No. 1 Race car classfieds
my105 - No. 1 Race car classfieds

9 items for sale

Refine Search

Clear All
Keyword
Price
Minimum
Maximum
Listing Type

All Results

8
Roll Cage
Log Book
S3 RX7 Rally car, fresh rebuild with only two events since completion. (2022 Alpine, 2023 Southern Cassic) 13B Bridge port with 48IDA, approx 250hp ATWs, stainless extractors, remote oil filter, new PWR oil coiler with new oil lines RX8 close ratio gearbox S3 4.89 LSD with strengthened housing MCA with remote canisters, two events old S4 steering, struts and 4 pot calipers All new wiring loom Twin carter fuel pumps Braided fuel and brakes through out Pedal box with Willwood cylinders Hydraulic h

Bittern VIC, Australia
Share
Watch
10
Ve commodore race car. Cage built to national standards and cams approved with all relevant certification,tilton pedal box,fuel safe fuel cell,completely resprayed inside and out including engine bay and inside boot in debeer 2k. Vehicle IS NOT A REPAIRABLE WRITE OFF and has had no body damage at all. Would be an excellent start for someone wanting quality race car. All cams work carried out by Garage 1 here in Victoria.

Kilmore VIC, Australia
Share
Watch
5
Registered
V8 Mazda Maxi Campervan S.A registered Holden 308 Possibly one of a kind Street registered with a Holden 308 turbo pattern engine. T400 three speed automatic transmission fully rebuilt with small stall Holley 600 fully rebuilt Custom exhaust Commodore rear end with welded diff Trans cooler and second radiator on bull bar Disk brakes all round The body is in fair condition and has been patched up and sprayed with a spray can Deck it out for a great Campervan Tow car for go carts Or remov

Adelaide SA, Australia
Share
Watch
9
Roll Cage
Log Book
2010 Holden VE Track Ute LS2 6L Engine. Tuned and Running with E85. OTR Cold Air Intake, Trunnion Upgrade. Both New Heavy Duty Rear Drive Shafts. New Radiator. New Power Steering Pump with Filter. Brembo 4 Pot Calipers on Front. Braided Brake Lines, Catch Can, Harrop Engine Oil Cooler. MCA Red Coilovers. National Level Roll Cage. PowerTune Digital (Fuel Guage, Oil Temp and Oil Pressure Guage, Coolant Temp Guage.) Improved Racing Oil Pan Baffle. Race Seats with 6 Point Harness on Driver Side and

Berwick VIC, Australia
Share
Watch
5
Registered
1979 fully restored rx7 series 1. Has hade full respray including jambs and engine bay. Restoration of interior. Original roof lining and door skins. Fully rebuilt factory 12a only done 500kms. Original wheels. Fantastic car.

Preston VIC, Australia
Share
Watch
26
Registered
Roll Cage
Log Book
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip

Lilydale VIC, Australia
Share
Watch
3
Roll Cage
RX8 drift/track car project I have since given up on due to work commitments and a lack of time. I'd rather avoid parting it out. Includes: S1 RX8 chassis (stat write off, perfectly straight, no damage or rust that I've found). - cut out OEM driver seat mounting to fit race seat lower (havent patched hole yet). Custom shortened front uprights New LCAs New brake rotors New PMU pads New braided front lines New Custom valved coilovers New wheel bearings/hubs Wet NOS kit (10lb bottle) Other rando

Edinburgh SA, Australia
Share
Watch
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute

Geelong VIC, Australia
Share
Watch
9
Roll Cage
Log Book
Mazda in excellent condition, recent service, garaged, Mazda BP GTR Motor with factory Ihi ball bearing Turbo, 221 KW @ rear wheels s/5 gearbox, new h/d tailshaft triple plate tilton, alloy flywheel 4.11 detroit locker.S/4 breaks all round ht 10 pads new front koni struts, harness, autometer gauges intercooler spray 48’s. CAMS log book. ID plates and could be registered if changed to roadworthy.

Adelaide SA, Australia
Share
Watch