10 items for sale
Most Recent
Most Recent
Keyword
Category
Price
Listing Type
All Results
6
Completely rebuilt over the last period of Covid, ground up restoration, has not been on a track since rebuild. Fitted with a Nissan FJ 20 ET engine with forged internals and Motec management. Will need testing and sorting, just been dynoed at low boost to give the engine a bit of run time, comes with mounted wets and spare new fronts, a complete new forged engine in dismantled form, 3 engine blocks and 4 cylinder heads, and a mass of spares including 2 gearboxes. Was originally raced bu Keith L
8
Roll CageLog Book
S3 RX7 Rally car, fresh rebuild with only two events since completion. (2022 Alpine, 2023 Southern Cassic) 13B Bridge port with 48IDA, approx 250hp ATWs, stainless extractors, remote oil filter, new PWR oil coiler with new oil lines RX8 close ratio gearbox S3 4.89 LSD with strengthened housing MCA with remote canisters, two events old S4 steering, struts and 4 pot calipers All new wiring loom Twin carter fuel pumps Braided fuel and brakes through out Pedal box with Willwood cylinders Hydraulic h
5
Roll CageLog Book
1984 Toyota AE86 Sprinter, Motorsport Australia Logbook. 4AG 1600 twin cam with 4-2-1 extractors. T50 5 spd manual transmission. New Exedy OEM clutch. Timing belt, tensioner, water pump, crank and cam seals replaced June 2019. Cusco strut brace. Aero bonnet latches, Front Tow hook, Rhino Alarm & Immobilser 6 point Motorsport Austrlia approved roll cage. Cobra Monaco Pro driving seat on RPM seat side mounts. Ecliptech SHIFT-i shift lights. Mains battery power shutoff switch. 4.3 LSD.
5
Registered
V8 Mazda Maxi Campervan S.A registered Holden 308 Possibly one of a kind Street registered with a Holden 308 turbo pattern engine. T400 three speed automatic transmission fully rebuilt with small stall Holley 600 fully rebuilt Custom exhaust Commodore rear end with welded diff Trans cooler and second radiator on bull bar Disk brakes all round The body is in fair condition and has been patched up and sprayed with a spray can Deck it out for a great Campervan Tow car for go carts Or remov
5
Registered
1979 fully restored rx7 series 1. Has hade full respray including jambs and engine bay. Restoration of interior. Original roof lining and door skins. Fully rebuilt factory 12a only done 500kms. Original wheels. Fantastic car.
26
RegisteredRoll CageLog Book
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip
3
Roll Cage
RX8 drift/track car project I have since given up on due to work commitments and a lack of time. I'd rather avoid parting it out. Includes: S1 RX8 chassis (stat write off, perfectly straight, no damage or rust that I've found). - cut out OEM driver seat mounting to fit race seat lower (havent patched hole yet). Custom shortened front uprights New LCAs New brake rotors New PMU pads New braided front lines New Custom valved coilovers New wheel bearings/hubs Wet NOS kit (10lb bottle) Other rando
7
Registered
race ready no expense spared r35 cams approved cage terra trip rally safe Stilo full KW canister shocks fully adjustable just been rebuilt worth $$$$$ full just jap gear box with gear set 11 plate clutches billet baskets Dodson at a cost of $25000 exchange about 2 events old billet front Dif housing hard race adjustable rear arms hard race front top arms rose jointed adjustable rear adjustable front adjustable sway bars and bushing winged seats fire bomb plumbed in engine and feet akropovi
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute
9
Roll CageLog Book
Mazda in excellent condition, recent service, garaged, Mazda BP GTR Motor with factory Ihi ball bearing Turbo, 221 KW @ rear wheels s/5 gearbox, new h/d tailshaft triple plate tilton, alloy flywheel 4.11 detroit locker.S/4 breaks all round ht 10 pads new front koni struts, harness, autometer gauges intercooler spray 48’s. CAMS log book. ID plates and could be registered if changed to roadworthy.