6 items for sale
Most Recent
Most Recent
Keyword
Category
Price
Listing Type
All Results
8
Roll CageLog Book
S3 RX7 Rally car, fresh rebuild with only two events since completion. (2022 Alpine, 2023 Southern Cassic) 13B Bridge port with 48IDA, approx 250hp ATWs, stainless extractors, remote oil filter, new PWR oil coiler with new oil lines RX8 close ratio gearbox S3 4.89 LSD with strengthened housing MCA with remote canisters, two events old S4 steering, struts and 4 pot calipers All new wiring loom Twin carter fuel pumps Braided fuel and brakes through out Pedal box with Willwood cylinders Hydraulic h
5
Roll CageLog Book
Future Racer. Ground up rebuild and conversion to Hayabusa completed February 2023. Debut in Miniature Thundersports at Mallala round 1, 2023 where it won the round. Car is fitted with a race built Hayabusa Gen2 built to 1441cc. Custom wiring, Mychron5 dash, custom headers and exhaust, hydra mat fuel system, Koya wheels fitted with Hankook slicks, velo seat and belts, OMP steering wheel, Flow Designs front lip and winglets, adjustable rear wing. Comes with Motorsport Australia Logbook and also
5
Registered
1979 fully restored rx7 series 1. Has hade full respray including jambs and engine bay. Restoration of interior. Original roof lining and door skins. Fully rebuilt factory 12a only done 500kms. Original wheels. Fantastic car.
26
RegisteredRoll CageLog Book
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute
20
Roll Cage
Unfinished project. Extensive chassis mods, 3/4 chassis kit, Watts link rear suspension, brand new Braced 9" diff, 3.9 gears and Detroit locker with 35 spline full floating axles strange nodular iron carrier. PBR M series brakes (vt-vz) 6 piston fronts and 4 piston rears, all 4 rotors are 2 piece design and 360mm. Tilton 9000 series brake pedal set Tremec 5 speed TKO box triple plate clutch 7&1/4 inch clutch 19" 3 piece simmons wheels FR19s 8" front 10"rear Coil over front end conversion Flaming