SSR Enabled
my105 - No. 1 Race car classfieds
my105 - No. 1 Race car classfieds

40 items for sale

Refine Search

Clear All
Keyword
Popular Vehicles
All
Price
Minimum
Maximum

All Results

9
Roll Cage
Log Book
NISSAN 300 ZX ROLLER, NO ENGINE OR TRANS FULL TUBE CHASSIS FOUR LINK REAR LIGHT WEIGHT SPINDLE MOUNT FRONT WHEELS 9 INCH DIFF WITH FULL FLOATER 40 SPLINE AXELS CENTERLINE CONVOPRO WHEELS BUILT FOR SUERSTOCK GAS CLASSES RAN 9.0 SECONDS 150 MPH IN D/GAS WEIGHT WITH 300 CUBIC INCH ENGINE WOULD SUIT TURBO CHARGED CLASSES

East Moonta SA, Australia
Share
Watch
18
Registered
Roll Cage
Log Book
38 Chevy 350 power, steering air conditioning airbag suspension in excellent condition will not be disappointed

Bittern VIC, Australia
Share
Watch
5
Registered
1979 fully restored rx7 series 1. Has hade full respray including jambs and engine bay. Restoration of interior. Original roof lining and door skins. Fully rebuilt factory 12a only done 500kms. Original wheels. Fantastic car.

Preston VIC, Australia
Share
Watch
9
Roll Cage
Log Book
COD and Australian Log Book now issued. Full ground up rebuild just completed by Souley Motorsport UK including full chassis strip, re powder coated, new floor, dampers rebuilt, new wheel bearings, new bulkheads and tank surrounds, gearbox rebuilt, callipers rebuilt, new master cylinders, new clutch slave cylinder and seals. Fresh BOLD motor prior to 2022 FF Festival, now with necessary AUS modifications. Recently fully prepared by Ellery Motorsport and raced to P4 at Winton Festival of Speed by

Flinders VIC, Australia
Share
Watch
12
Roll Cage
Log Book
R33 GTR Spec log booked and trailer and spares. Done 144 lap time at Phillip island with not the best driver. New rebuilt motor RB26 forged with -5 turbo's and Motec m800 with dash. Engine only done 1 hour run in time. R34 reco 6 gear box with triple plate clutch, also avalable at extra,Trust dog box with another triple plate clutch. Harrop brakes front 6 spot rear 4 spot. BC modified suspension. Two sets of Advans wheels and tyres 18x9 with Yokohama semi slicks. 12 point roll cage cams apro

Brunswick East VIC, Australia
Share
Watch
28
Roll Cage
2002 Nissan Skyline R34 GTR MSPEC tuned by Full Stage Japan HKS STEGE III 2.8L STROKER KIT GT2530 x 2 EVC F-COM NEW GEAR BOX (GETRAG) CARBON TRIPLE PLATES CLUTCH IKEYA FORMULA LOWER ARM INJECTORS FUEL DELIVERY FUEL COLLECTOR TANK ARC RADIATOR FRONT INTER COOLER TRUST MUFFLER CARBON DOORS CARBON BONNET CARBON LID DRY CARBON REAR WING ENDRESS BRAKE CALIPER (MONO BLOCK) NISMO METER BOOST 1.2 550 ~ 580 PS BOOST 1.7 600 ~ 630 PS Only ran 300kms after the engine build Car is still in Japan $180,0

Adelaide SA, Australia
Share
Watch
5
Roll Cage
Log Book
Sports sedan raced 180 SX , worked Turbo SR20 with standard gear box, Skyline front and rear uprights with Koni coil overs. 180s diff fabricated housing with 2 diffs ( 1:3.9 and 1:4.2).Motec ECI , full Cams cert roll cage and log book. Fibreglass doors, hatch , Bonet and front guards, ex Holden super car rear wing, fuel cell, race seat and window net. I could never drive it to its potential. Last driven 2019 Bathurst 6 hr. Health issues have limited my racing unfortunately. I have a car trailer,

Dromana VIC, Australia
Share
Watch
10
Roll Cage
Log Book
Gary Hansen RaceCraft built (USA) ex Pro Stock, complete roller, Koni electric shocks, Race Pack dash, race pack SC 1000 data logger, Lamb brakes, Ron Davies radiator, 40 spline Mark Williams axels, Weld Magnum wheels.. too much to list Has gone 7.22 @ 191 mph, will suit a wide variety of classes This car has less than 200 passes Please call for more information

Andrews Farm SA, Australia
Share
Watch
11
Roll Cage
Log Book
1992 S13 Nissan Silvia. SR20 DET Log Booked Race Car 8 Point Tower to Tower roll cage. Comfortably fits 6’4” driver MCA coil overs with remote reservoirs SR20 built and tuned by JPC 260kw at the wheels Garret Turbo Intercooler sprayer Motec Computer with standalone engine loom Motec Dash S14 5 speed built by Neat Gearboxes 2 way Diff Strengthened S14 rear subframe Fully adjustable rear suspension with alloy knuckles S14 front X member and strengthened LCAs Alloy fuel tank Surge tank Braid raci

Victoria, Australia
Share
Watch
20
Roll Cage
Time to go unfortunately, Chevy Belair, new build not quite finished. Set up for A Gas and or 1/8th mile. Diff - new Chevy 12bolt with Lenco spool 5.44 gears and Summers Bros axles and "C" clip eliminator kit new tailshaft. Wheels are 15x14.5 Centreline Pro stacks with 32in slicks, 15x5 frontrunners. New cage, tubs etc. Torana front end and steering with SPAX adjustable front shockers. Engine - Sawka built, original 454 LS7 Big block, Crane R260 roller cam, lifters, rockers, Hilborn injection. T

Melrose Park SA, Australia
Share
Watch
12
Roll Cage
Nissan S13 Silvia with S15 front RB26DETT fresh -7’s Forged internals Nitto oil pump & collar Remote oil cooler & filter Custom catch can & overflow HKS cams (264 9.1) HKS injectors, Bosch fuel pump Custom front pipe & side pipe Motor originally built by Top Fuel Japan, has had rings and bearings done since, linished & straightened crank, new rods & pistons. Nitto head gasket Rb25 gearbox with 26 internals (better synchromesh etc) 200mm xtreme twin plate clutch Nissan 4 pot front brakes DBA roto

St Marys SA, Australia
Share
Watch
26
Registered
Roll Cage
Log Book
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip

Lilydale VIC, Australia
Share
Watch
3
Roll Cage
RX8 drift/track car project I have since given up on due to work commitments and a lack of time. I'd rather avoid parting it out. Includes: S1 RX8 chassis (stat write off, perfectly straight, no damage or rust that I've found). - cut out OEM driver seat mounting to fit race seat lower (havent patched hole yet). Custom shortened front uprights New LCAs New brake rotors New PMU pads New braided front lines New Custom valved coilovers New wheel bearings/hubs Wet NOS kit (10lb bottle) Other rando

Edinburgh SA, Australia
Share
Watch
7
Registered
race ready no expense spared r35 cams approved cage terra trip rally safe Stilo full KW canister shocks fully adjustable just been rebuilt worth $$$$$ full just jap gear box with gear set 11 plate clutches billet baskets Dodson at a cost of $25000 exchange about 2 events old billet front Dif housing hard race adjustable rear arms hard race front top arms rose jointed adjustable rear adjustable front adjustable sway bars and bushing winged seats fire bomb plumbed in engine and feet akropovi

Klemzig SA, Australia
Share
Watch
10
Roll Cage
Set up for drag racing 13b turbo engine - 640 rwhp (last dyno) Power glide gearbox (newly rebuilt) with 7500rpm stall with bump system Microtech LT10s ecu - 3 bar & 2 step Handmade 9" diff, Mark Williams alloy center 35 spline axels 4.8:1 4 link suspension and coil-overs not pictured: wheelie bars, parachute

Geelong VIC, Australia
Share
Watch
18
Major upgrades include, uprev tune 5 stage by rev zone, 230kw @ 6764rpm (315kw at fly wheel) coil overs with eibach linear springs - 9.5kg rear / 11kg front. Cusco RS 1.5 weigh LSD Z1. Motor sport dif cooling cover AP racing 6 pot front brake kit with endless ME20 pads. Akebono 2 piece rear rotors with endless ME20 pads. Stillen front splitter Stillen front canards. Z speed aluminium under shroud. Rev Zone custom front alloy under tray. Evo R rear wing, Stillen gen 3 long range intakes, Stillen

Thomastown VIC, Australia
Share
Watch
9
Roll Cage
Log Book
Mazda in excellent condition, recent service, garaged, Mazda BP GTR Motor with factory Ihi ball bearing Turbo, 221 KW @ rear wheels s/5 gearbox, new h/d tailshaft triple plate tilton, alloy flywheel 4.11 detroit locker.S/4 breaks all round ht 10 pads new front koni struts, harness, autometer gauges intercooler spray 48’s. CAMS log book. ID plates and could be registered if changed to roadworthy.

Adelaide SA, Australia
Share
Watch
4
RE LISTED Nissan Exa Sports Sedan ROLLER Cams log book Well known Victorian car. Full space frame / fibreglass panels. Built to suit 20b rotary. Left hand drive. Lots of original spares, supra gearbox and remote shifter, tail shaft, R200 diff (plus spare) Full 20b exhaust system, muffler and side outlet. Moulds, spare fiberglass bonnet and front spoiler, clutch & flywheel, front engine mount & engine / gearbox mount plate. 16x10 wheels with slicks and spare 15x10 with wets. Fuel tank, lines with

Macedon Ranges, VIC, Australia
Share
Watch
15
Full roller ready for any engine combinations you wish Nissan Skyline r33 1995 full roller $14,000 Motor an all parts to do with motor is sold Only have the gearbox available If not I will just keep the car As I have owned this car for over 21 years I started building it about 15 years ago and then it was put into storage for over 10 years Car still has got all of its identification plates The rego run out about 16 years ago I believe it still can be registered in south Australia Ch

Glenalta SA, Australia
Share
Watch
43
Registered
We are pleased to present, this 2022 Corvette Stingray 3LT, finished in Torch Red with a Natural Dipped Tan interior. This C8 generation was the first to introduce the mid-engine platform and with this car’s open roof, it offers an exotic experience unlike any previous Corvette. The new mid-engined layout allowed the all-new C8’s ‘wedge’ shaped body, a styling cue typically found in exotic European sports cars. These new aggressive bodylines are perfectly complemented by an equally powerful dri

Richmond VIC, Australia
Share
Watch