31 items for sale
Most Recent
Most Recent
Keyword
Price
Listing Type
All Results
8
Fully enclosed with opening doors all round for complete access. Also has tilt for ease of loading, ramps store underneath Internal measurements are 3320mm length at full width and another 750mm in the front taper section, 1685mm wide and 1410mm high. Canopy is all brand new in 2022, Front mounted winch .Only selling as a new car does not fit.
9
Reverse cycle split system air conditioning, Tv/dvd player, Wired for 240 and 12 volt power and lights, Floor and side mount tool boxes, Heavy duty electric leg makes even low cars easy to load, Remote winch and on board battery with roof top solar panel, Rear wind down stabilisers, 4 wheel electric brakes and controller, 4 tonne axles and hubs, New tyres, Carpet in front/vinyl in rear, Plenty of tie down points, Plenty height inside for storage, Empty weight 1700kg, Total weight up to 3500kg,
15
Group A VL Walkinshaw Genuine Twin Throttle Body Intake Mainfold and genuine rocker covers to suit. In excellent condition (taken off near new engine, over 30 years ago). Genuine, original idle control, fittings and hoses. Genuine, mint condition rocker covers (polished). Taken off my own personal group A engine in 1990 and has been owned and stored by myself for over 30 years. Has not been tampered with or ported, in its original state. Still has original thermostat, housing and sensors a
3
Seeking Oz Magnesio rims for my ex Nations Cup ’99 996 GT3. Seeking a set or individual rims Cheers Stewart
4
Three (3) S2 soft compound Semi Slick 205/50R15 Dunlop Direzza race tyres with about 75% tread remaining Each has done only 2 sprint meets. A total of about 80Km track distance. Initially $400 each. Selling for $100 EACH
15
Racing trailer $47,000 + gst 75mm ball 2.6 metre sides Sprintcar and mule both fit with spare wing Another spare wing could be mounted in there Tyre rack Front wing spares holder Front axle and diff holder Fuel can holders Shock holders Spare bar holders Built by Diverse Transport Located in Penola SA
3
Racepak G2X datalogging dash GPS module and rpm sensor Oil temperature gauge, wire and fitting Water temperature gauge, hose and fitting. All gauges autometer ultralite 2 1/16" complete dash and logger plus all gauges for a new install. Everything working, removed form racecar
4
Bought these wheels to make trailer wheels for a formula car however didn't work out. The centres have been machined out so ready for your custom centre to be installed
2
Up for sale is my 12a bridge port engine was rebuild but has been pulled down for freshen up and has 12a twin dizzy housings in it. All in great condition. Comes with everything except stationery gears as need them for my build. Housings have been matched to porting. Going turbo so not needed. Pm me for photos they take forever to upload. Cheers
6
ICEngineworks 2000 series full kit. Most of the kit hasnt been taken out of packaging. Used the blocks once. Great kit to use. No longer needed. Cost $3000au landed after import tax.
3
Wanted - an OEM Matter factory front and rear roll cage from a 1999 996 911 GT3 CS. Also after a set of Factory Schroth red harnesses as the car would have been delivered with new. .... some one must have one (or a mate with one) lying around. Sing out if you’ve any other GT3 bits to sell too Cheers Stewart Kay Adelaide SA