31 Mazda for sale
1/2 CHASSI CAR series 6 bridge port turbo Air shifted liberty Floating 9" 4 link rear Koni's plenty Shocks and sway bar Runs easy low 8's plenty more in combo MW Ignition Data Logger new parachute new front tyres new rear slicks new harness Andra and IHRA TECH INSPECTED
Group Nc Historic Touring Car, current log book, immaculate condition, 20+ years of development. Matt Russell race engine, special PAR gear box, Hossack gear shift, two MFR limited slip diffs 4.44 and 4.77, full floater diff spare axle, Savy watts link, 5 sets of wheels and tyres (new wets), new stainless exhaust system, AES muffler, three sets of new brake rotors. Matching Carbon Race seats, original trim and back seat. Also available by negotiation is a customised trailer to suit, plus a
Many hours and dollars have gone into bringing this RX7 Sports Sedan back to track spec after sitting dormant since 2004. See start-up video https://www.youtube.com/watch?v=LPjiyKQ-SUY I purchased this car a couple of years ago and it went straight to the original engine builder John Perkins (VIC) who went through the mechanicals, freshened the engine and updated the MOTEC to an M1 package with new motorsport sensors through out. It has done dyno runs only since. It runs an early Racing Beat
Log Book 3D Sports sedan, ground up rebuild, all new rose joints and bolts, new control arms, new MCA Shocks, new full mil spec wiring, New Motec M84 ECU, New C125 dash,all new master cylinders,brake line, oil lines, fuel lines, new fuel pumps and pressure reg, New GTR R32 diff and limited slip centre, AP Rotors and calipers, New PWR oil cooler, 3 sets 16" wheels, tyres are crap, all internal and under body sheet metal, some moulds, NO ENGINE OR GEARBOX, was 13b turbo and H6S holinger, still hav
The time has come for us to move on from our RX8 Cup Car. For sale is our 2004 Mazda RX8 Cup Car. This car is a regular in the top 5 on track with multiple podiums, but due to a lack of time to race it is time to move it on. It meets all current specs and is ready to roll straight onto the track and go racing for the remainder of the 2022 season or take some time and make it your own, ready for 2023 Included: • Motorsport Australia Log Booked • Engine: Engine was replaced last year and has
Open for expressions of interest is the “Silver Spud” - my 1979 Mazda 323 (Rear Wheel Drive) Improved Production car (3J rules). This car has been hand built by an experienced racer from the ground up with the best of everything. It has only three race meetings since completion, and is showing amazing potential as we progress with improved chassis tuning. If you are considering building your own EM turbo IP car, look no further. Here is a summary of the build sheet: Chassis: Clean, straight
Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip
2003 RS II Roadster MX5 Race Car for sale. Looks like funds are needed elsewhere. So up for sale is my Race car • 2003 RSII Eunos Import • Full Cage with side intrusion protection, everything is stripped out. It is a chassis, engine, cage, seat and steering wheel. • Tupperware body kit • Sparco Seat and SAAS Harness. • 1.8L VVT Engine – full rebuild just late last year with forged internals. • Custom intake behind front right headlight. Headlight backing removed for cool air. • 2.5” Custom Exhau
Car was purpose built to run into the 7’s as a street driven car, just like all of spot on’s toughest cars. Car still has all body tags for registration! All work has been done by Spot On Performance in Brisbane. Full build gallery can be found here: https://www.facebook.com/media/set/?set=a.1214426645312666&type=3 No expenses spared on this build. Everything is BRAND NEW, NEVER RUN. Complete chromoly chassis 4 link rear with full floater spot on sheet metal 9” housing Billet strange cen
Rx7 space frame chassis roller Minus engine , gearbox , ecu & seat Go gear built chassis no. 6691- 07 Lotus uprights Air jacks Koni shocks Centreline wheels + spare set Spare diff Will sell box seperate from chassis
Mazda RX7 Sports Sedan. Ex Ivan Mikac Go-Gear built car. Ground up restoration 2018-2020 including chassis/body, transaxle and engine. 2021 Tasmanian State Champioship winner. 12a turbo, Hewland FGB with long and short track ratios, 8 spare wheel centres. Short and tall drivers seats. Can assist with transport if required.
Mazda series 2 RX7 improved production with rolling shell. No engine, no gearbox Bilsteen shocks Coilovers Nissan Calipers Pan Hard Bar rear diff set up, equal length arms. Modna LSD 4.8 to 1 ratio Adjustable break bias in cabin Pedal box 2 sets of AO50’s Yokohama wheels plus tyres. Call Matt Russell 0423273337
Mazda Coupe, Mazda BP GTR Motor with factory Ihi ball bearing Turbo, 221 KW @ rear wheels s/5 gearbox, new h/d tailshaft triple plate tilton, alloy flywheel 4.11 detroit locker.S/4 breaks all round ht 10 pads new front koni struts, harness, autometer gauges intercooler spray 48’s. CAMS log book. ID plates and could be registered if changed to roadworthy.
2017 build, Logged Booked 3J well sorted easy fun car to drive and run, loads of grip, only quality parts used. 113,000 Kms on Car, Built in Australia raced in UK. I’ve only had the car out twice since moving back to Australia, Time at QR 1:26, Time Lakeside at 1:03 Safety • AGI Roll cage • Sparco Circuit Seat on adjustable rails • Sparco Steering wheel • Fire Bomb (Needs refill) • Window net • Battery Relocation and Kill switch Tuning • Cobb Access Port (The car is e tuned so don’t ha
Series 1 RX7, CAMS logbooked 3J, S4/5 13b, bridgeport built by Rotortorque, only 4 race meets old. Garrett T04 turbo, Microtech LT10. Makes 410hp at 16psi, on E85 only. Still on wastegate pressure, will easily make over 500 comfortably with more boost. S5 turbo gearbox, Kaaz diff. CAMS spec weld in roll cage. AP racing brakes including bias adjuster. Big fuel system, TAARKS surge tank with 2 x 460s, twin carter lift pumps, Indy blue injectors just been serviced and flow tested. All PTFE fuel lin
The 2021 Australian SuperUte championship winning EFS Ute is available right now prepped and ready for round 1 of the 2022 series. Peel off the wrap and put your design on and go racing. The 22' series is 6 rounds covering all states except NT. All rounds are with Supercars and races shown live on Fox and Kayo. Some will also be shown on 7. We reckon Ute has always and is still the best bang for buck national racing in Australia. You can run these Utes your self with mates or have them transport
For sale is the Dick Ward Go Gear sport sedan. As built and driven by Dick in sport sedan races in the 80s. This car presents in excellent condition. - 13b PP engine using MFR factory peripheral port housings and making 300hp. - Hewland transaxle stamped as ex F1 F.Williams. - full chromoly space frame chassis - magnesium uprights - lots of top spec features as raced in the day. - 600kg makes it an absolute blast to drive and extremely fast This car is eligible to run as invited in Historic
Hi guys up for regrettable sale is my 1983 mazda rx7 rally car. This car over the years has been deveolped and made to be one of the best cars of its kind. It has won numerous state level events and clubman championships and in the right hands would be an outright position rally car. This is a log booked rally car with cams approved cage. I will list below the modifications etc. Suspension- Mca gold remote canister front shockabsorbers ( rebuilt 1 event ago) Apx suspension remote canister r
Mazda 808 coupe highly modified for racing. Built to Cams 3j ipra rules, with Cams approved Wildridge fabrications full roll cage and log book, suitable for many motorsport activities. Motec M84 ECU (enabled), Motec C125 display (race kit enabled), Motec PDM15 (runs all lights etc, no fuses or relays required). Full car professionally rewired by Armour motorsport with Tefzel mil spec wire. Mazda bp1.8 built by Boostworx of Adelaide with Manley rods, wiseco pistons, arias wrist pins, kings race
Complete with 408 Cleveland with chi 3 heads,gold crane roller rockers,ross pistons,chi manafold, new quick fuel cab methanol 750 - est 650+ horsepower 2 speed power glide, TCI convertor Brand new still In box - ice ignition, CVR starter, Meziere water pump, B&M shifter,Magna fuel pump,tacko and shift light +oil/water gauges, fuel cell. Brand new - 9 inch diff with floaters, 4 link bars, ybar, strange housing and steering wheel, wheel wood brake lines,king spring front shocks. Full chassis